 |
Kold Flo® Data Sheet
A modified asphalt emulsion crack filler designed for maintenance of asphalt
and concrete pavements.
Features and Advantages:
Ready to Use - Apply Kold Flo from the original container, with a pour pot, or a drum pump
for faster application.
Minimal Preparation - No waiting for kettles to heat up. Crews are ready to go in minutes.
Safe Application - No burns from hot applied material. Kold Flo is a ready-to-use, cold applied, pourable crack filler.
Easy Application - No expensive equipment or experience needed.
Reduced Traffic Delay - When properly applied, Kold Flo can be driven over within 30 minutes without tracking.
Application Directions:
PREPARE: Blow or sweep debris from cracks.
APPLY: Pour Kold Flo into the crack, 3/4 of the length. Allow a few minutes for Kold Flo to seep down into the crack.
COMPLETE: Using a "U" shaped squeegee push Kold Flo into the crack allowing the excess to fill the remaining 1/4 length of the crack. Add more Kold Flo if necessary. If cracks are deeper than 2", a second application may be required.
Additional Information:
- KEEP FROM FREEZING! Kold Flo is an asphalt emulsion and must be stored at temperatures above 35°F.
- Kold Flo should be applied when the ambient temperature is at least 50°F with no chance
of rain for 8 hours. Extraneous water will destroy Kold Flo if it has not yet cured.
- Kold Flo stored longer than three months may require stirring due to slight settling.
- Clean tools with water immediately after use. If Kold Flo is cured, use only EPA approved solvents for cleaning. If Kold Flo dries on hands, use only EPA/OSHA approved hand cleaners.
|
Coverage:
For Cracks Measuring:
1/4"(wide) x 1/4"(deep) = 300 linear feet
1/2"(wide) x 1/2"(deep) = 75 linear feet
1"(wide) x 1"(deep) = 25 linear feet
Back to FAQs
|
